Concept illustration
Industry primers for UAV system builders.
Educational articles on supply-chain layers, control–power matching and low-altitude component priorities, not customer case studies.
Start with architecture, then matching, then mission.
Each note is written to help teams ask better interface questions before locking a BOM.
UAV Thermal Imaging Payloads: Radiometric Selection
How to select a thermal imaging payload for UAV inspection — radiometric vs non-radiometric cores, NETD and thermal resolution, IR lens and IFOV math, thermal-visual fusion, gimbal integrati
UAV Firmware OTA Update Strategies: Secure Remote
A procurement engineering guide to over-the-air firmware updates for UAVs — signed firmware and secure boot, A/B partition and atomic update, rollback and fleet version control, update behav
UAV Payload Arming and Safe-and-Arm Interlocks
How UAV payload arming works — safe-and-arm interlock architectures, inhibit logic, dual-redundant release paths, safe/arm pin design and the RFQ clauses that make an unintended release impo
UAV Powerline Inspection Components: Towers & Corridors
Specify the LiDAR, radiometric thermal and high-zoom EO payloads, EMF-hardened avionics and endurance airframe for UAV powerline inspection — corridor mapping, joint and insulator condition
UAV Oil & Gas Inspection Components: ATEX and Gas
UAV components for oil and gas inspection — ATEX and intrinsically safe electronics, methane detection payloads, flare stack thermal surveys and corrosion-resistant airframes for offshore an
UAV RF Spectrum Management: Frequency Coordination
Licensed vs unlicensed bands, FCC Part 87, ETSI harmonized standards, DFS in 5 GHz and the RFQ checklist for spectrum-ready UAV radios.
UAV Communication Protocols: CAN, DShot, PWM, SBUS,
A procurement and integration guide to UAV communication protocols — CAN bus, DShot, PWM, SBUS, CRSF (Crossfire) and serial telemetry — comparing latency, bandwidth, noise immunity, wiring t
UAV Composite Airframe Inspection: NDT Methods
A technical guide to non-destructive testing (NDT) of UAV composite airframes — the defect classes that matter in carbon fiber structures, tap testing, ultrasonic A/B/C-scan, thermography, s
UAV Field Charging and Power Logistics: Generators,
A procurement guide to UAV field charging and ground power logistics — sizing the field energy budget, inverter generators, solar and portable power stations, vehicle-based DC charging, batt
Heavy-Lift UAV Propulsion Design: Motors, ESCs,
Engineering guide for heavy-lift UAV propulsion — selecting low-KV motors (100–200 KV), high-voltage ESCs (12S–14S CAN FD), matched propellers and Li-Ion battery packs for drones carrying 10
UAV High-Temperature Operation: Components for Hot
What heat does to UAV components — battery derating and thermal runaway, motor and ESC current limits, propeller thrust loss in hot thin air, dust ingress and a hot-weather procurement check
UAV Precision Landing and Docking Systems:
How UAV precision landing works — RTK, visual markers and IR beacons compared, the sensor stack, docking station hardware, contact charging and a procurement checklist.